Self-Locking Washer for Stick Pins (1-1/2" Diameter)

Self-Locking Washer for Stick Pins (1-1/2" Diameter)

Use these self-locking washers to secure your stick pin install. They're easy to install and a reliable way to secure insulation in place on walls and ceilings. Made in the USA!

Specs

Installation Instructions

1. Apply Adhesive – Spread a thin layer of pin adhesive on the back of the perforated base.
2. Press in Place – Firmly press the base against the wall or ceiling until adhesive comes through the perforations.
3. Mount Insulation – Pierce insulation onto the pin so it sits flush against the surface.
4. Lock & Trim – Slide a self-locking washer and then trim the excess length. If using dome caps, installing the cap after trimming the excess length.