Overkill™ is the thinnest and lightest noise filter on the market but it is also one of the strongest performers in the industry.
Apply a single layer of Overkill™ on top of your Damplifier and Spectrum vibration damper to filter out specific sound waves interfere with your audio system clarity. Overkill will not only reduce resonant echoes from your sound system, but it will also help to eliminate unwanted ambient sounds that interfere with the tonal quality of your music.
Overkill™ is also thin enough to get applied to some areas of the cars upholstery to cushion rattles and squeaks, helping to improve the overall acoustical environment of you car.
There are 2 types of noise in any automobie:
-Structure borne noise
-Air borne noise
Products like Damplifier and Spectrum reduce structure borne noise by absorbing the vibrations in your cars sheet metal, but they do little to reduce airborne noise. This is where Overkill comes in.
When applied on top of our Spectrum or Damplifier vibration dampers, Overkill filters out airborne sound waves that are able to penetrate the layers below it.
Add a layer on top of your vibration damper to reduce road noise, engine noise and exhaust noise.
This is the easiest and least expensive step you can take to dramatically enhance your Damplifier™ and Spectrum™ installation.
Specifications:
| Thickness | .125 in | (3.17 mm) |
| Mass/Area | .013 lbs/Sq.Ft. | (.063 kg/m²) |
| Heat Tolerance | 225 °F | (107 °C) |
| Sheets | 24inX54in | (60.96cmX137.16cm) |
* requires separate adhesive - not included
Applying a layer of Overkill on top of your Damplifier or Spectrum vibration dampers is the easiest way to improve the acoustics in your car.
First, Overkill will reduce the airborne sound waves that are able to penetrate the vibration damper. This reduction in unwanted noise will equate to in increase in the desired noise which is your music.
Overkill will also reduce the intensity of distortion causing reflections inside your vehicle. The less noise that is bouncing around the car walls, the louder and clearer your audio system will sound.
Specifications:
Thickness .125" (3.17 mm)
Mass/Area .013 lbs/Sq.Ft. (.063 kg/m²)
Heat Tolerance 225 °F (107 °C)
Sheets 24 x 54 (116.84cmX182.88cm)
* requires separate adhesive - not included
Anything you place in front of the heat source will help reduce or slow down the heat. Overkill will help reduce heat to a small degree but is not specifically designed to do so. Any heat reduction noticed from Overkill is purely a side benefit, not an intended result.
For The ultimate in heat damping protection, use a combination of Damplifier Pro followed by Heat Wave Pro
Specifications:
| Thickness | .125 in | (3.17 mm) |
| Mass/Area | .013 lbs/Sq.Ft. | (.063 kg/m²) |
| Heat Tolerance | 225 °F | (107 °C) |
| Sheets | 24inX54in | (60.96cmX137.16cm) |
|
